Come On Get Snappy

get snappySnapdragon anyone? I’ve offered this simple project at a number of programs in the past, and it’s always well-received. “Snappy” has decorated the edges of a swamp at a Halloween party, hid in an Alice in Wonderland garden, and grown out of pots at a “Primordial Plant” event table!

event tableYou’ll need:

  • 1 paper cup
  • 1 small rectangle of green construction paper for head (approximately 1.5″ x 3″)
  • A sliver of red construction paper for tongue
  • 1 green pipe cleaner
  • Hole punch
  • Tape
  • Markers
  • Extra green construction paper for leaves

First, fold the green construction paper rectangle in half to form Snappy’s mouth. Tab the ends of the mouth, then cut out teeth.

mouth stepsMake sure to leave a gap in the lower teeth (this is where the tongue will rest later).

gapNext, punch a hole in the back of Snappy’s head…

punched holeThen thread a green pipe cleaner through the hole. Twist the pipe cleaner around and thread it through the hole once again. Pull gently to tighten, then curl the end.

stem steps

 Cut the sliver of red construction paper to look like a forked tongue and tape (or glue) it into the mouth.

tongueUse markers to draw eyes. I added my eyes at the very end, but younger kids might have an easier time drawing the eyes earlier, such as before they attach the head to the pipe cleaner stem.

close up of faceTape the pipe cleaner stem inside the paper cup. Use extra green construction paper to add foliage. Done! Perhaps you can test out your new Snappy skills with this garden story time?

Bedtime? What Bedtime?

jake stays awakeTime for bed? Not for this little fellow. His head barely touches the pillow before he launches himself out of bed! The secret: a craft stick catapult concealed beneath the covers!

jumping out of bedWe read Jake Stays Awake by Michael Wright (Feiwel & Friends, 2007). Jake refuses to sleep in his own bed, preferring instead to knock on his parents’ door at night and insist on joining them. But it’s definitely not working for his parents. So they make a deal. Jake can sleep with them, but perhaps he can think of a different place for them to bed down for the night? So they try many places (including the roof, the stairway, the kitchen counter, garbage cans, the family car) until exhausted Jake finally hits on the one place that might just work – his own bed.

You’ll need:

  • A box (mine was 4 ½” X 4 ½” x 9”)
  • A 5″ x 5″ square of tagboard for the headboard
  • A 3″ x 4.5″ rectangle of tagboard for the footboard
  • Extra pieces of tagboard for bed decor
  • 2 jumbo craft sticks (mine were 6″ long)
  • 6 medium craft sticks (mine were 4.5″ long)
  • A selection of colored masking tape
  • 2 medium rubber bands
  • A small rectangle of white poster board for pillow (mine was 2.25″ x 2.5″)
  • A rectangle of tissue paper for blanket (mine was 5.25″ x 7″)
  • 2 toilet paper tubes
  • A selection of multicultural construction paper
  • A selection of patterned paper
  • Construction paper for hair
  • A small rectangle of stiffened felt for teddy bear (mine was 1.5″ x 2″)
  • Scissors, tape, and glue stick for construction
  • Markers for decorating
  • Hot glue

We’ll start with the bed! Cut the box down until it is approximately 2.5″ deep.

bed steps Now cut your headboard and footboard out of tag board. Make sure the footboard is low and rounded. Otherwise, your tube person might not clear it when catapulted.

headboard and footboardHot glue (or tape) the headboard and footboard to the ends of the box. To create some texture on the bed frame, we made some simple tag board shapes. The kids decorated them with markers and glued them to the bed.

finished bedOn to the catapult! Stack 2 jumbo craft sticks on top of one another, then wrap a rubber band tightly around one side.

rubber banded craft sticksNow stack 6 medium craft sticks on top of one another and wrap both ends tightly with colored masking tape.

taped craft sticksWedge the stack of 6 craft sticks in between the jumbo crafts sticks like so:

wedgedThen wrap a second rubber band around both sets of craft sticks to secure the catapult mechanism (a criss-cross wrap works best).

bandedHot glue the stacked craft sticks to the inside center of the box. Really glob the hot glue on. You don’t want the catapult to come loose!

catapult securedCut a toilet paper tube in half lengthwise, then cut a 1.25″ segment off the bottom of one of the halves. This is the “catapult cup” that will hold the lower section of your tube person steady whilst it awaits launching. Attach the catapult cup with hot glue, but avoid getting hot glue on the rubber bands.

catapult cupRound the edges of the white poster board rectangle to create a pillow, then hot glue it to the top of the catapult arm. The pillow should be flush with the end of the craft stick.

pillow placementFinish by draping the tissue paper “blanket” over the top of the catapult.

blanket placementThe catapult is ready. Now for your person! Wrap the top of a toilet paper tube with a strip of multicultural construction paper. Then wrap the remainder of the tube with patterned paper. Add construction paper hair and use markers to draw a face.

Lastly, cut arms and legs from the patterned paper and tape to the tube. Make sure, however, that you attach the arms and legs to the front of the tube. This produces the best launch from the catapult.

side view finished personPlace your person on top of the catapult. His/her head should rest on the lower part of the pillow, and his/her rear end should rest in the catapult cup. But before you launch, how about a fuzzy companion? I cut a teddy bear shape out of white stiffened felt and used Sharpies to add some details. Then I prepped a bevy of bears for story time!

lots of bearsPlace the teddy bear on top of the tube person. Then reach between the posts of the headboard and press firmly down on the top edge of the pillow.

press down Remove your finger quickly and watch as your person launches out of bed, teddy bear flying!

launch

Let it Shine

dream friendsTwinkle twinkle little light! Are your ready for your journey to dreamland? This beautiful lantern and dream friend will help guide you on your way!

little lantern

We read Dream Friends by You Byun (Nancy Paulsen Books, 2013). Melody has a very special friend…a dream friend. They fly, play hide-and-seek, have marvelous adventures, and watch fireworks. But only in her dreams. In reality, Melody is a shy girl in a new neighborhood. Since her dream friend can’t leave her dreams, Melody decides to close her eyes and imagine her friend is with her. While dancing on the playground, Melody draws the attention of another little girl who asks to join her. Soon, the whole playground is dancing with Melody. Magical!

You’ll need:

  • A 5″ plastic bucket container (more on this below)
  • A 3.5″ x 5″ rectangle of mirror board
  • Foil star stickers (the kind you find at office supply stores)
  • Regular markers
  • Hole punch
  • 1 LED votive candle
  • A set of window markers
  • Lullaby CD
  • A selection of shimmer ribbon
  • Gold curling ribbon

A bucket container (also sometimes called a craft container) is constructed of plastic and metal. It’s meant to hold party favors, candy, etc. I purchased mine from Oriental Trading Company. You can purchase them individually at Michael’s Craft store.

bucket container

To begin this project, use regular markers to draw a “dream friend” on the back of the mirror board (i.e. the white, non-reflective side). You could use white card stock instead of mirror board, but the mirror board is fantastic at reflecting the light of the lantern in the dark.

When cutting out your dream friend, make sure to leave a little tab at the top. Punch a hole through this tab (and round the edges if you’d like). This is where your ribbon will go later.

dream friend steps

Open the bucket container and stick the foil stars on the “floor” of the container and the underside of lid. Some kids stuck stars on the plastic sides of the container. This is fine – just make sure they keep the stickers on the interior of the container so they won’t interfere with the markers later.

Now for the fun part. I dropped a twinkling LED votive in each container, darkened the room, put on a lullaby CD ( I highly recommend Sweet Dreams: Lullabies for Guitar by Nina Gerber), and the kids used window markers to decorate the exterior of their containers. The room was full of excited yet peaceful kids, decorating away amidst mellow, glowing lanterns.

dream workshop

A tip about window markers. I purchased this brand from Discount School Supply (alas, there is no purple marker in this set). I know from experience that this particular brand works on glass AND plastic.

window markers

You have to draw slowly with window markers and allow them a little time to dry (about 30-45 second). Once they completely dry, then you can go back over them with another color. Otherwise, they get smudgy. So if you want to draw little stars with smiley faces like mine, just wait 30-45 seconds before you use the blue marker to draw the face on the yellow star.

decorated container

To complete the project, thread some shimmer ribbon and gold curling ribbon through the punched hole in the dream friend, then tie to one side of the lantern. Sweet dreams!

lit up